Hi everyone.
I have a old Isel cnc milling machine , and i am having problems.
My machine is not running at full speed at all.
With no load at all , not even sled on it my maximum is 15mm/s and i should be able to go to 45-50mm/s
the steppers are STP-57D313-01 , i have no idea who makes them , and i now nothing about stepper motors.
I can use the machine fine when i run 15mm/s but i would like to be able to mill at speeds of maybe 25-30mm/s.
I only mill in wood.
My motors are from feb. 1997. ( can my motors be worn out )
The machine was used at Bang and Olufsen factory in denmark for only 3-4 months , and then it just sit and wait.
So the machine has not been used very much but is old.
Hope to hear from you.
I can make videos , take picture if needed.
Best wishes Kristjan
Isel MBP 2030 / CPM 2030
Re: Isel MBP 2030 / CPM 2030
Software u use?
Sorry for my bad english : )
Sorry for my bad english : )
Wer ist online?
Mitglieder in diesem Forum: 0 Mitglieder und 22 Gäste